U1844 BMW Fault Code

Description:

The Transmission Fluid Pressure Switch allows the engine's control module (PCM) or Transmission Control Module (TCM) to use hydraulic fluid to engage the clutches in the transmission to allow for smoother shifting while driving. If the PCM or TCM detects an issue with the hydraulic clutch or the pressure switch, the BMW PCM or TCM will set code U1844

U1844 Code Symptoms :

When you turn on the ignition, the Service Engine Soon or Check Engine U1844 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the U1844!

Diagnosis And Repairing U1844

U1844 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to fix U1844 code ?

• Exhaust tube
• Failures of clutch motion/travel sensors.
• Camshaft Position Sensor harness is open or shorted
• Engine Control Module (ECM)

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code U1844, so consult the manual to locate the brake fluid reservoir.

Bear in mind that a low fluid level can set code U1844 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.